5 Ton Rockwell Wilwood Rotors Product Description:

WILWOOD CAST IRON HIGH SPEED ROTORS

TECH TIP: YOU MUST MACHINE THE 5 TON ROCKWELL PINION FLAT FLANGE TO FIT OUR WILWOOD ROTOR> 

A) THE OUTER DIAMETER MUST BE TURNED DOWN SMALLER TO FIT INTO THE 8 PAD RECESS ON THE ROTOR

B) THE BACK SIDE OF THE 5 TON ROCKWELL PINION FLAT FLANGE MUST BE TURNED DOWN FLAT SO THE TAPER IS GONE 

C) A NEW 8 BOLT PATTERN HAS TO BE DRILLED OUT TO 3/8" SO THE ROTOR WILL BOLT UP. PLEASE STAGER THIS BETWEEN DRIVE SHAFT BOLT HOLES (BOTH BOLT HOLE PATTERNS ARE SLIGHTLY DIFFERENT FROM EACH OTHER AND WILL NOT WORK)

. 

THESE ROTORS ARE BUILT OUT OF HIGH TEMP CAST IRON THAT WILL DISSIPATE OVER 1000* F TEMPS

THESE ROTORS ARE SPINNING @ 7 TIMES THE SPEED OF 1 REVOLUTION OF THE TIRE

11.750" OUTER DIAMETER,

x

.810" THICK

.

WARNING: THESE CAN NOT BE USED FOR STREET USE , FAILURE WILL OCCUR